Skip to content
English - United States
Contact us
  • There are no suggestions because the search field is empty.

HYPERLOK® Application Instructions: 40ml Refillable Applicator

Complete step-by-step instructions for applying HYPERLOK® with the 40ml refillable applicator system.

Complete step-by-step instructions for applying HYPERLOK® with the Jumbo Marker(40ml) system.

Overview of the Refillable Precision Application System

This guide provides step-by-step instructions for properly cleaning build surfaces and applying HYPERLOK® adhesive for optimal 3D printing results.

  • ⚠️Clean with plate removed from machine - do NOT spray cleaner inside machines!
  • ⚠️Ensure plate is COOL - do NOT apply when HOT!
  • ⚠️Make sure Z-Offset is properly calibrated!

Cleaning the Build Surface

Materials Needed

  • 50/50 Isopropyl Alcohol/Water solution
  • Spray bottle
  • Microfiber or dust-free towels

Steps

  1. Prepare cleaning solution: Mix 50/50 Isopropyl Alcohol/H₂O solution in a spray bottle
  2. Apply solution: Spray onto build plate with microfiber or dust-free towel
  3. Let soak: Allow solution to sit for 10 seconds
  4. Wipe clean: Remove solution completely
  5. Repeat process: Apply solution again and wipe with new towel or clean side
  6. Visual inspection: Verify plate is completely clean before proceeding

Applying HYPERLOK®

Prepare applicator: Shake the refillable applicator bottle well, then remove lid

Prime the tip (first use only): Press down until tip is soaked. The wide tip will require about 1/4 of the bottle. Replacement tips are available for purchase.

Apply HYPERLOK®: Push tip firmly against buildplate with light pumping action while moving around print area

Create pattern: Distribute HYPERLOK® in a hatch/grid pattern until evenly applied

Drying time: Let dry for approximately 3 minutes before heating the bed

Print with confidence: Your parts will be securely adhered to the surface

Troubleshooting Adhesion Issues

If you experience adhesion problems, try these adjustments:

  • Lower Z-Offset by -0.02mm increments
  • Increase bed temperature by 10°C increments
  • Increase first layer temperature by 5°C increments

Part Removal Guidelines

For bed temperatures 100°C or less:

Let parts cool fully in the build chamber before removing

For bed temperatures 120°C or more:

Let parts cool partially in the build chamber and remove while warm

Maintenance Tips

  • Clean fully between coats - layering coats will NOT increase adhesion
  • Each surface application will last multiple prints
  • Refill applicator when fluid level reaches the "Refill soon" marking on side gauge
  • For refill instructions, see: HYPERLOK 240ml Refill Pump Bottle Instructions